Steel Fender for Sportster 82 to 03

CUSTOM FENDER

for Harley Davidson Sportster XL models from 1982 to 2003

Can also be used for all kinds of bobber projects.

There are no holes, the fender can be attached to the original struts.

No holes for the taillight.

• Total length measured over the arc ca. 760 mm
• Span length ca. 640 mm
• Width inside (front and back) ca. 175 mm, in the middle ca. 190 mm
• Total height ca. 220 mm
• Material thickness: ca. 1,2 mm steel sheet

NOTE: Only a specialist may carry out all the works on the entire vehicle. In the event of deviations from the vehicle component manufacturer, you have to consult the Association for Technical Inspection center for safety reasons.
When using attachments within the Road Traffic Licensing Regulation, the existing laws regarding dangerous vehicle parts must be observed in the road traffic and/or be advised before installation at the relevant vehicle registration office or the Association for Technical Inspection center.
Important, for chassis parts as well as fenders,the fitting accuracy must be checked before Working: Punching, Cutting, Painting!